Storm Creek Coating delivers durable, oven-cured powder finishes on parts, equipment, frames, wheels, and one-off projects. Stripped, blasted, coated, and cured under one roof.
From single brackets to full restorations, we handle prep, coating, and cure under one roof — with the same care whether the part is one of one or one of a hundred.
TGIC polyester, epoxy, and hybrid powders applied electrostatically and cured for a finish that won't chip, crack, or fade.
↗ /02Aluminum oxide and steel-shot media for full strip-down prep. The right profile for adhesion that lasts.
↗ /03Steel and alloy wheels stripped, prepped, and coated in any color or finish — from factory-match to candy-coat.
↗ /04Trailers, equipment, machinery. Stripped down, repaired where needed, and refinished to better-than-new.
↗ /05Railings, gates, patio sets, and exterior steel. Super-durable powders rated for UV and salt-spray exposure.
↗ /06Bring us a chip, a tag, or a paint code. We source or mix from 2,000+ stock powders to land your color.
↗Every job follows the same four steps — because shortcuts on prep are why coatings fail. We don't take them.
Old paint, rust, grease, and corrosion come off. Chemical strip or thermal burn-off depending on the substrate.
Media-blasted to bare metal with the right profile for the powder system. Cleaned, masked, and racked for spray.
Electrostatic spray application in a controlled booth. Even film build, sharp edges, no runs or thin spots.
Baked at 350–450°F until the powder cross-links into a hard, chip-resistant shell. Cooled, inspected, packed.
Gloss, matte, satin, textured, hammertone, candy, metallic, fluorescent. If it exists in powder, we can put it on your part.